CCNA Routing & Switching ICND2 200-105
Course Description
CCNA Routing & Switching is probably the most popular Cisco certification there is. There are two certifications:
- CCNA ICND1 100-105
- CCNA ICND2 200-105
This course covers everything in ICND2 and you will learn more about the things you learned in ICND1, and some new topics!
Course Highlights
In this course you will learn:
- Learn the basics of networking.
- How to configure VLANs and Trunks on Cisco Catalyst switches.
- The difference between spanning-tree and rapid spannning-tree
- The OSPF routing protocol and how to configure it.
- Cisco’s EIGRP routing protocol and how to configure it.
- How the BGP routing protocol is used for Internet routing.
- How to configure access-lists to protect your network.
- How QoS (Quality of Service) gives preference to certain traffic on your network.
- How to configure WAN (Wide Area Network) protocols and interfaces.
- And many other topics…
Presented to you by instructor Rene Molenaar, CCIE #41726
Requirements
- Good understanding of all topics covered in ICND1.
Lessons
- Introduction to Spanning Tree
- Why do we need QoS on LAN Switches
- QoS trust boundary on Cisco Switches
- Introduction to VLANs
- VLAN Configuration on Cisco IOS Switch
- Trunking on Cisco IOS Switch
- Introduction to VTP (VLAN Trunking Protocol)
- How to configure Router on a Stick
- Introduction to OSPF
- Basic OSPF Configuration
- OSPF DR/BDR Election explained
- Introduction to EIGRP
- EIGRP Unequal Cost Load Balancing
- Basic EIGRP Configuration
- How to configure EIGRP Summarization
- Introduction to Cisco IOS Access-Lists
- Wildcard Bits explained
- Standard access-list example on Cisco Router
- Extended Access-List example on Cisco Router
- Introduction to IPv6
- Stateless autoconfiguration for IPv6
- IPv6 Neighbor Discovery Protocol
- How to configure IPv6 Static Route
- IPv6 EIGRP on Cisco IOS Router
- IPv6 OSPFv3 on Cisco IOS Router
- How to configure HDLC on Cisco IOS Router
- Introduction to PPP on Cisco IOS Router
- EIGRP Packets explained
- Detailed look at EIGRP Neighbor Adjacency
- EIGRP Neighbor and Topology Table
- EIGRP Queries and Stuck in Active
- OSPF Packets and Neighbor Discovery
- How to configure OSPF Default Route
- How to configure EBGP (External BGP)
- Block website with NBAR on Cisco Router
- QoS Traffic Shaping Explained
- QoS Traffic Policing Explained
- GRE Tunnel on Cisco IOS Router
- GRE Tunnel Recursive Routing Error
- How to configure SNMPv3 on Cisco IOS Router
- EIGRP Variance Command Example
- Cisco PPPoE Server Configuration Example
- 802.1Q Native VLAN on Cisco IOS Switch
- Cisco DTP (Dynamic Trunking Protocol) Negotiation
- Etherchannel on Cisco IOS Catalyst Switch
- Cisco IOS SPAN and RSPAN
- Spanning Tree Cost Calculation
- Per VLAN Spanning Tree (PVST)
- Spanning Tree Port States
- Cisco DHCPv6 Server Configuration
- EIGRP K Values Formula
- 802.1Q Encapsulation Explained
- Cisco Portfast Configuration
- OSPF LSA Types Explained
- Internal BGP (Border Gateway Protocol) explained
- QoS Marking on Cisco IOS Router
- IP Precedence and DSCP Values
- QoS Classification on Cisco IOS Router
- Rapid Spanning Tree (RSTP)
- Rapid Spanning Tree Configuration
- Spanning Tree BPDU Guard
- InterVLAN Routing
- Introduction to Gateway Redundancy
- HSRP (Hot Standby Routing Protocol)
- AAA and 802.1X Authentication
- AAA Configuration on Cisco Switch
- DHCP Snooping
- Cisco Stackwise
- Cisco Switch Virtualization
- BGP Neighbor Adjacency States
- Shortening IPv6 Addresses
- How to find IPv6 Prefix
- IPv6 EUI-64 explained
- How to configure SNMPv2 on Cisco IOS Router
- Troubleshooting EIGRP Neighbor Adjacency
- IPv6 Summarization Example
- Introduction to BGP
- IPv6 Solicited Node Multicast Address
- BGP Messages
- How to Read the BGP Table
- How to advertise networks in BGP
- EIGRP Passive Interface
- EIGRP Static Neighbor
- EIGRP K Values Configuration
- EIGRP Default Network Route
- EIGRP Auto-Summary
- OSPF Passive Interface
- OSPF Hello and Dead Interval
- OSPF Router ID
- OSPF Reference Bandwidth
- IPv6 Address Types
- IPv6 Address Assignment Example
- IPv6 Access-list on Cisco IOS
- IP SLA (Service-Level Agreement) on Cisco IOS
- Cisco IOS Time Based Access-List
- Introduction to SNMP
- Introduction to MPLS
- Introduction to DMVPN
- Introduction to SDN (Software Defined Networking)
- Introduction to SDN OpenDayLight
- Introduction to APIC-EM
- APIC-EM Path Trace ACL Analysis Tool
- Voice VLAN
- Introduction to WANs (Wide Area Network)
- Introduction to Cloud Computing
- IPv6 OSPFv3 Default Route
- Single/Dual Homed and Multi-homed Designs
- AAA Authentication on Cisco IOS
- Chassis Aggregation
- OSPF Multi-Area Configuration
- PPP MultiLink
- Introduction to QoS (Quality of Service)
- Introduction to VPNs
- Introduction to Metro Ethernet
- How to study for Cisco CCNA R&S