We're Sorry, Full Content Access is for Members Only...

If you like to keep on reading, Become a Member Now! Here is Why:

  • Learn any CCNA, CCNP and CCIE R&S Topic. Explained As Simple As Possible.
  • Try for Just $1. The Best Dollar You've Ever Spent on Your Cisco Career!
  • Full Access to our 637 Lessons. More Lessons Added Every Week!
  • Content created by Rene Molenaar (CCIE #41726)

 

374 New Members signed up the last 30 days!

satisfaction-guaranteed

100% Satisfaction Guaranteed!
You may cancel your monthly membership at any time.
No Questions Asked!

Tags: , , , ,


Forum Replies

  1. Hi Hans,

    The default is src mac based load balancing.

    From SW1’s perspective this is a great choice as each computer has a different MAC address. Traffic from the computers will be load balanced when it is sent from SW1 to SW2.

    From SW2 to SW1, it’s another story. The MAC address of the router remains the same so using src mac based load balancing is not a good idea. All traffic will be sent using the same physical interface. It’s better to change it to dst mac address load balancing since the destination MAC address will be one of the four computers.

    The same

    ... Continue reading in our forum

  2. Hey Austin,

    Having more bandwidth over a trunk is a great thing! We will be carrying traffic for many subnets/vlans over a trunk so the bigger we can make the pipe with an etherchannel the better.

    Also LACP is a protocol that can be used by many different computers and vendors you can run LACP on servers and switches which is great. PAgP is a Cisco proprietary protocol so it can only be ran between Cisco equipment. I hope this helps!

    Thanks,
    Scott

  3. I understand about the trunk. My understanding was a bit flawed. I was thinking we were combining a path and then seperating it again.

    Also, if we are on a network built entirely with cisco gear, is there a better choice between LACP and PAgP? If so, why and when is one better?

    Thanks in advance!

  4. I dont think there is a difference between the two in regards to pros and cons. The only advantage I could see is that PAgP might be “quicker” to configure since the default protocol used for etherchannel is PAgP on Cisco equipment. After some googling there was no clear advantage I seen. One advantage of both LACP and PAgP is they help prevent loops manual etherchannel configurations do not allow for this. I hope this was helpful!

73 more replies! Ask a question or join the discussion by visiting our Community Forum